![]() Thread the wires through using a glow rod.Ī glow rod is basically a hook on the end of a flexible but fairly study cord.You can then trim it where required when fitting the socket box. It is better to cut too small than too big, so stick within the lines to start off with. Using a 6 inch plasterboard saw carefully cut around the stencil. Double check cable length and hole positioning.ĭid anyone else grow up being told ‘measure twice, cut once.’? Or did you learn the hard way ?Before you regret it 5 minutes later take the time to check everything over – you’ll only be kicking yourself afterwards if you get it wrong!.Mark the spot in pencil first and step back to make sure you’re happy rather than rushing in with the drill. Remember to place it high enough so that the wires that naturally sag below the plug will still be hidden. We would suggest looking at the back of your storage unit/cupboard and identifying the most direct route for the cable. Similar to above, you want this to be hidden behind the unit or tucked out of the way in the cupboard. Select the best position to cut your second hole behind unit or within built-in cupboard.Using the socket box as a stencil draw around the box. Draw around socket box onto plasterboard wall.If you fail to do this, you will need to remove the whole wall bracket when you want to add or remove a wire instead of just the TV. Next take a look at your bracket and identify the best space within the framework to position your hole so that it is hidden behind your TV but not trapped behind an element of the metal frame. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |